A race car's front wing, 40 mm across and 10 deep: a printed main plane with a rounded nose that tapers from 2 mm to a 0.8 mm trailing edge, a flat 2 mm pad at its centre with one tapped M3 hole, and two end plates 6 mm tall. It prints flat with no supports and screws up into the tip of the nose's L Bracket with a countersunk M3 from the bracket's inside.
- Made by
ReDo.Pro- Kind
- Parametric part
- Licence
- CC-BY-SA-4.0
- Keywords
- wing, front wing, F1, race car, racing, end plates, 3d printed, formula 1, m3
| Overall size (X × Y × Z) | 40 × 10 × 6 mm |
|---|---|
| Volume | 713 mm³ |
It prints in one pose: as modelled. The app measures each at the values set: its size on the bed, first layer, overhang to bridge or support, and PLA.
