A LEGO Technic connector read off LDraw: an angle connector, a Ø7.2 hub on a pin hole or an axle hole with arms bored for an axle, one, two straight or bent to 168.75, 157.5, 135, 112.5 or 90 degrees, three spaced 120 degrees apart, a Y of three or a fan of four 60 degrees apart; the axle joiner, two modules of the arms' flat-sided section with an axle hole through, or the ridged one, Ø7.2 with four flats and three ridges round it, its axle hole square to the flats or across them; the double joiner, two axle holes a module apart; a connector hub, the same hub on a pin or axle hole with an axle or a friction pin standing out of its side, one, two straight or at an angle, or three 120 degrees apart; a hub on an axle hole with four 3.2 mm bars standing out of it; an axle joiner with an axle 1.5 standing out of it; a 2 x 3 block of three axle cells, the middle one two modules long, joined by I-beams; or the round pin joiner, a Ø7.8 tube two modules long, counterbored for a pin at each end and slotted round half its middle.

Made by

ReDo.Pro

Kind

Parametric part

Licence

CC-BY-SA-4.0

Keywords

LEGO, Technic, connector, angle connector, axle joiner, pin joiner, connector hub, axle, pin, ridged joiner, double joiner, bar, pole reverser