The 2 mm-pitch GT2 pulley a 3D printer runs its belts on, cut to the published curvilinear groove: three tangent arcs of 0.15, 1 and 0.555 mm across a 1.494 mm tooth, 0.764 mm deep. Twenty teeth on a 5 mm bore with an 8 mm hub is the one on a NEMA 17. The toothed section takes whatever belt width it has to carry, the hub runs from a full clamping boss down to a 1 mm retaining flange, and a fixed 1 mm flange always caps the top. Two M3 grub screws at 90 degrees clamp the hub to its shaft.
- Made by
ReDo.Pro- Kind
- Parametric part
- Licence
- CC-BY-SA-4.0
- Keywords
- gt2, 2gt, pulley, timing pulley, timing belt, belt, drive, printer, cnc, nema 17
| Pitch | 2 mm |
|---|---|
| Pitch line offset | 0.254 mm |
| Profile | GT2 |
Its overall size is measured once the 3D view has built it.
It prints in one pose: as modelled. The app measures each at the values set: its size on the bed, first layer, overhang to bridge or support, and PLA.
