A printed 30 × 20 × 27 mm body that, with its 3 mm lid, wholly encloses a 9 g micro servo — an MG90D, MG90S or SG90 — once its mounting ears are cut off. The servo drops into a pocket open at the top and stands on a 4.2 mm floor, its spline on a grid line 20 mm from the front; the Micro Servo Case Lid screws down over its shoulder with four countersunk M2 screws, and the gear tower and spline come up through it. The body is the one piece a build fastens to: tapped M3 holes into the floor, both long sides and both ends, and a slot in the back end that the cable drops into.
- Made by
ReDo.Pro- Kind
- Parametric part
- Licence
- CC-BY-SA-4.0
- Keywords
- case, housing, servo case, servo mount, micro servo, sg90, mg90s, mg90d, 9g, enclosure, 3d printed, bracket
| Overall size (X × Y × Z) | 30 × 20 × 27 mm |
|---|---|
| Volume | 8.5 cm³ |
It prints in one pose: as modelled. The app measures each at the values set: its size on the bed, first layer, overhang to bridge or support, and PLA.
