The 30 × 20 × 3 mm lid that closes the top of the Micro Servo Case and holds the servo down by its shoulder. The servo's gear tower and spline come up through a 15.5 × 12 mm opening, standing a little proud of the lid so a horn turns clear of it, and four countersunk M2 screws at the corners hold it to the body.
- Made by
ReDo.Pro- Kind
- Parametric part
- Licence
- CC-BY-SA-4.0
- Keywords
- lid, cover, case, servo case, micro servo, sg90, mg90d, 3d printed, m2, countersunk, mg90s, 9g
| Overall size (X × Y × Z) | 30 × 20 × 3 mm |
|---|---|
| Volume | 1.2 cm³ |
It prints in one pose: as modelled. The app measures each at the values set: its size on the bed, first layer, overhang to bridge or support, and PLA.
