A printed 80 × 30 × 27.8 mm body that, with its 2.2 mm lid, wholly encloses the yellow TT gearmotor with its end tab cut off — 80 × 30 × 30 closed, every side shut. The motor drops into a pocket open at the top, its shaft on the grid: on the second row's second hole, 15 mm in from the end and the side, and its lower end flush with the underside. Two M3 × 30 countersunk screws come down through the TT Motor Case Lid and the motor's own gearbox holes into the floor, so the lid clamps the motor to the body. The body is the piece a build fastens to: tapped M3 holes on the 10 mm grid in three rows on both long sides and both ends, in the underside around the shaft, and down into the far end through the lid.
- Made by
ReDo.Pro- Kind
- Parametric part
- Licence
- CC-BY-SA-4.0
- Keywords
- case, housing, motor case, tt motor, yellow motor, gearmotor, dc motor, enclosure, 3d printed, m3
| Overall size (X × Y × Z) | 80 × 30 × 27.8 mm |
|---|---|
| Volume | 35.7 cm³ |
It prints in one pose: as modelled. The app measures each at the values set: its size on the bed, first layer, overhang to bridge or support, and PLA.
