The 80 × 30 × 2.2 mm lid that closes the top of the TT Motor Case over the gearmotor. Two M3 × 30 countersunk screws go in through it, through the motor's gearbox holes and into the body's floor, so the motor is clamped between the two. The shaft's top end comes out through a 7 mm hole on the grid, a hole takes the locating peg on that side of the gearbox, a slot over the motor's terminals lets its wires out, and three M3 holes at the far end pass screws down into the body.
- Made by
ReDo.Pro- Kind
- Parametric part
- Licence
- CC-BY-SA-4.0
- Keywords
- lid, cover, case, motor case, tt motor, yellow motor, 3d printed, m3, countersunk
| Overall size (X × Y × Z) | 80 × 30 × 2.2 mm |
|---|---|
| Volume | 4.9 cm³ |
It prints in one pose: as modelled. The app measures each at the values set: its size on the bed, first layer, overhang to bridge or support, and PLA.
