One half of a printed 90 × 20 × 20 mm case for one 18650 cell, split along the cell's axis: two of it, one turned over onto the other, close round the cell. Four M3 set screws join them, each threaded halfway into the tapped M3 hole that runs through each half at its ends, which leaves the outer end of every hole to fasten the case into a build. Windows in all four long faces show the cell, and each end carries tapped M3 holes on the 10 mm grid in its face and sides. A tapped M3 hole on the cell's axis at each end, split between the halves, takes a contact screw. An 18650 Cylindrical Battery seats in it.
- Made by
ReDo.Pro- Kind
- Parametric part
- Licence
- CC-BY-SA-4.0
- Keywords
- case, battery case, battery holder, battery box, 18650, li-ion, cell, half, split case, set screw, 3d printed, mount, power
| Overall size (X × Y × Z) | 90 × 20 × 10 mm |
|---|---|
| Volume | 6.9 cm³ |
It prints in one pose: upside down. The app measures each at the values set: its size on the bed, first layer, overhang to bridge or support, and PLA.
