An L bracket that turns the Micro Gearmotor Case's shaft through a right angle with a pair of bevel Spur Gears. Its 2.5 mm leg screws flat to the case's side with four countersunk M3 × 5 screws and carries a 3 mm D shaft where it crosses the motor's, and its 20 mm foot lifts the case 10 mm and screws down to a Plate. Ratio picks the pair: 1:1 for two 8-tooth gears, 1:2 for an 8 on the motor and a 16 on the shaft, 1:3 for an 8 and a 24, each set to mesh with the other. The motor's gear sits with its back on the case's front and the shaft's gear with its back on the leg, so the bracket is 35, 40 or 45 mm long, 30 tall and 20 wide.
- Made by
ReDo.Pro- Kind
- Parametric part
- Licence
- CC-BY-SA-4.0
- Keywords
- bracket, L bracket, bevel, right angle, gearmotor, N20, reduction, drive
| Overall size (X × Y × Z) | 40 × 20 × 30 mm |
|---|---|
| Volume | 4.5 cm³ |
It prints in one pose: as modelled. The app measures each at the values set: its size on the bed, first layer, overhang to bridge or support, and PLA.
