A printed 30 × 20 × 20 mm case for the N20-size micro metal gearmotor, three grid cells long and two square. The motor slides in from the back, its gearbox face against a 3 mm front wall, and its 3 mm D shaft comes out through the middle of the front; the pocket holds it, so the motor's own M1.6 mounts go unused. Every face but the back carries tapped M3 holes on the 10 mm grid, short of the motor, so the case fastens to Blocks, Plates and brackets like a Block does; the back closes with the Micro Gearmotor Case Lid on two M3 screws. Fits the bare-back motors; an encoder or an extended back shaft is longer than the pocket.
- Made by
ReDo.Pro- Kind
- Parametric part
- Licence
- CC-BY-SA-4.0
- Keywords
- case, housing, enclosure, motor case, n20, micro metal gearmotor, gearmotor, 12 mm, 3d printed, mount
| Overall size (X × Y × Z) | 30 × 20 × 20 mm |
|---|---|
| Volume | 7.9 cm³ |
It prints in one pose: on its side, Y −90°. The app measures each at the values set: its size on the bed, first layer, overhang to bridge or support, and PLA.
